Step 5 ;Place the final floor panel face up, locking groove long side towards the wall, and the short end tongue positioned 3/16 to 5/16 inch from the wall. Mark the place where the floor panel is to be cut. Make a cut in the floor panel on the decor side with a utility knife. Use the snap method to break the unneeded part off.Kingfisher Vinyl Flooring Click Product Installation Guide.

Step 6 ;Stagger the end joints between rows at a minimum 12 inches. If you can, use the cut piece of floor panel from the previous row. If not suitable, take a new floor panel and cut it in half. Place the floor panel at a low angle and insert the long side tongue into the locking groove of the floor panel in the previous row. Fold the floor panel gently down.

Step 7 ;Place the short end tongue of the next floor panel at an angle against the previously installed floor panel and fold gently down.  Ensure that the long side tongue is positioned on the locking strip of the previous row.

Step 8 ;Using gentle force and at an angle, you gradually, from left to right, push the long side tongue into the locking groove of the previous row. You may need to lift the floor panel to the left of it slightly to allow for the;sliding action;Complete the whole row in the same way.