Step 1
Pre-install Activities  Ensure that the width of first and last row is not less than 2 inches wide.Measure the distance of room in the direction of the width of the plank. Divide the distance by the width of the plank. Multiply the number beyond the decimal point of the by the width of the plank. This is the width of the last plank. If it is less than 2 inches, you must cut the first plank. Determine the width of the first and the last row by adding the calculated width of the last plank to the width of a whole plank. Divide this number by two. Subtract the expansion gap from the
result. The result is the width of the first and last row.  Rack up planks from several boxes.  Ensure that end joints are staggered at least 12 between the rows.  Inspect product for defects. If material is questionable, contact the retailer immediately. Do not proceed with installation.

Step 2 Cut off the unsupported tongue of the first row so that a clean, solid edge is towards the wall. If the first row of floor panels had already been trimmed in width to meet minimum requirement, there is no need to trim it again.

Step 3 Install the product from left to right, across the room. Place the floor panel with the locking groove facing the room. Ensure there is expansion gaps. Between floor and the wall and all vertical fixtures during installation.

Step 4 Place the short side tongue of the next floor panel at an angle into the short
side groove of the first one and fold down. Continue with the next floor panels in the same way.